Does it can generate the config normally? pls stop asterisk and run the the following command in turns to try
service dahdi stop
modprobe dahdi
modprobe opvxd115
dahdi_genconf
if still have problem, you can contact me via msn or skype
msn: This email address is being protected from spambots. You need JavaScript enabled to view it.
skype: chunlei.yi
Downloaded and installed all packages per instructions
....
cd dahdi-linux-complete-2.7.0+2.7.0/
make
make install
make config
List of detected DAHDI devices:
No Hardware found
OS: Linux 2.6.32-358.11.1.el6.x86_64 #1 SMP Wed Jun 12 03:34:52 UTC 2013 x86_64 x86_64 x86_64 GNU/Linux
lspci -vvvv
02:00.0 Network controller: OpenVox Communication Co. Ltd. D130P/D130E Single-port E1/T1 card (3rd GEN) (rev 15)
Subsystem: Device 0005:0000
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr+ Stepping- SERR+ FastB2B- DisINTx-
Status: Cap- 66MHz- UDF- FastB2B- ParErr- DEVSEL=slow >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
Latency: 32 (8000ns min, 32000ns max), Cache Line Size: 64 bytes
Interrupt: pin A routed to IRQ 11
Region 0: Memory at c1b00000 (32-bit, non-prefetchable) [size=32K]
Downloaded and installed all packages per instructions
....
cd dahdi-linux-complete-2.7.0+2.7.0/
make
make install
(all ok)
make config
List of detected DAHDI devices:
No Hardware found
Sorry I posted this on another thread...and have repeated in this new thread.
Please help....thank you